Symptom Remedy/Cause
4 General
No sound, sound interrupted or
static noise.
Check the cords, aerial and cable connections.
Check the condition of the connected device and recorded
tracks.
“MISWIRING CHK WIRING THEN
RESET UNIT”/“WARNING CHK
WIRING THEN RESET UNIT”
appears on the display and no
operations can be done.
Ensure the terminals of the speaker leads are properly insulated
with tape before resetting the unit. (' page 2)
If the message does not disappear, consult your JVC car audio
dealer or kits supplying company.
The unit does not work at all.
Reset the unit. (' page 2)
Source cannot be selected.
Check the <SRC SELECT> setting. (' page 15)
The correct characters are not
displayed (e.g. album name).
This unit can only display letters (upper case), numbers, and a
limited number of symbols.
4 FM/AM
SSM automatic presetting does
not work.
Store stations manually.
4 USB/iPod/iPhone
“READING” keeps flashing on the
display.
A longer readout time is required. Do not use too many
hierarchical levels and folders.
Reattach the USB device.
Tracks/folders are not played
back in the order you have
intended.
The playback order is determined by the file name.
“NOT SUPPORT” appears on the
display and track skips.
Check whether the track is a playable file format.
“CANNOT PLAY” flashes on
the display.
The unit cannot detect the
connected device.
Check whether the connected device is compatible with this
unit. (USB: ' page 19) (iPod/iPhone: ' page 17)
Ensure that the device contains files in the supported
formats. (' page 16)
Reattach the device.
The iPod/iPhone does not turn
on or does not work. *
Check the connection between this unit and iPod/iPhone.
Detach and reset the iPod/iPhone using hard reset. For
details on resetting the iPod/iPhone, refer to the instruction
manual supplied with the iPod/iPhone.
Check whether <IPOD SWITCH> setting is appropriate.
(' page 9)
* For KD-X40 only.
Troubleshooting
Troubleshooting
18
|ޓENGLISH
2011/11/8ޓ22:24:41KD-X40_E_EN
To Next Page
Loading...
Need help?
General
