1-2 (No.MA347)
SPECIFICATION
KS-AR7002
Design and specifi cations are subject to change without notice.
KS-AX5602
Design and specifi cations are subject to change without notice.
Power Output 150 W RMS x 2 channels at 4 Ω and [< or =] 1% THD + N
Signal-to-Noise Ratio 80 dBA (reference: 1 W into 4 Ω)
Maximum Power Output 800 W
Load Impedance 4 Ω (2 Ω to 8 Ω allowance)
4 Ω (4 Ω to 8 Ω allowance) (Bridge Mode)
Frequency Response 5 Hz to 50 kHz* ( +0, -3 dB)
* Subsonic fi lter cuts off extremely low frequency signals less than 20 Hz.
Input Sensitivity/Impedance 2 V/45 kΩ (0.3 V to 6 V, variable)
Distortion Less than 0.04% (at 1 kHz)
Power Requirement DC 14.4 V (11 V to 16 V allowance)
Grounding system Negative ground
Dimensions (W × H × D) 15-3/4 inch × 2-3/8 inch × 11-3/8 inch (400 mm × 60 mm × 288 mm)
Mass (approx.) 11.5 lbs. (5.2 kg)
Maximum Power Output 800 W
RMS Power Output 150 W RMS x 2 channels at 4 ? and [< or =] 1% THD + N
Load Impedance 4 Ω (2 Ω to 8 Ω allowance)
4 Ω (4 Ω to 8 Ω allowance) (Bridge Mode)
Frequency Response 5 Hz to 50 kHz* ( +0, -3 dB)
* Subsonic fi lter cuts off extremely low frequency signals less than 20 Hz.
Input Sensitivity/Impedance 2 V/45 kΩ (0.3 V to 6 V, variable)
Distortion Less than 0.04% (at 1 kHz)
Signal-to-Noise Ratio 80 dBA (reference: 1 W into 4 Ω)
Power Requirement DC 14.4 V (11 V to 16 V allowance)
Grounding system Negative ground
Dimensions (W × H × D) 400 mm × 60 mm × 288 mm
Mass (approx.) 5.2 kg
To Next Page
Loading...
Need help?
General
