JVC L-A11 User Manual

4. When playing ends and the pick-up cartridge enters the
lead-out groove which is spaced out, the engagement
advances more then it is returned by the projection.
Because of this, the engagement is pressed by the
projection as shown in Fig. 4, causing the main gear to
turn and engage with the turntable spindle gear. Thus
the change cycle is started.
5. During the return operation the engagement and lower
trip which have moved are returned to their original
position by the reject button coming into contact with
the bottom of the lower trip. At this moment the switch
lever operates with the help of the main gear cam,
switching off the power just before the rotation should
stop.
This completes the automatic cycle.
Tonearm lift and return mechanism:
1. When the main gear starts to rotate at the end of
playing, the return lever rotates under the action of the
main gear cam to press the elevator cam. The upward
movement of the elevator cam is directly converted into
movement of the elevator, lifting up the tonearm. (Fig.
5)
2. The tonearm is returned by the arm lever the end of
which presses it as the main gear rotates. (Fig. 6)
Trip Slide
Fig. 6
4. Cartridge Replacement
=
. Unscrew the connector nut to remove the headshell.
2. Remove the two long screws on the headshell which
hold the cartridge.
3. Connect the lead wires of the headshell to the new
cartridge, being careful to match the polarities correctly.
Polarity and wire colors are as follows:
White (+)...... L Red (+). ..... R
Blue (-)....... LE Green (-)..... RE
4. Attach the cartridge to the headshell squarely, and
gently tighten the screws.
5. Set the cueing lever to “DOWN”, and then bring the
stylus tip to the optimum position by sliding the
cartridge back and forth. See 5-(1) Overhang Adjustment
6. After attaching the cartridge, slide the headshell into
the tonearm with the connector pin fitting in the groove.
Tighten the connector nut.
L-A11
Fig. 3
Fig. 4
Return lever
Fig. 5
7. Be sure to adjust the tracking force and lead-in position
after replacing the cartridge.
Groove
Connector pin
Nee
Plastic
washer —=
/ Gene
Connector nut
Headshell
Cartridge pin
aT
Cartridge body
Leer ts
Stylus
Fig. 7
No. 246°

JVC L-A11 Specifications

General

Brand	JVC
Model	L-A11
Category	Turntable
Language	English