JVC LT-32C655B Quick Start Guide

• DonotconnecttheTVtothemainssupplyuntilyouhavecompletedalltheconnections.
• AlwaysdisconnecttheTVfromthemainssocketwhennotinuseforalongperiodoftime.
• The
buttonontheremotecontrolisonlyusedforswitchingtheTVintostandby,itdoesnotdisconnecttheTVfromthemainspower.
Tocompletelydisconnectthemainspower,pleaseremovethemainsplugfromthemainssocket.
TheLCDdisplayisveryfragile,andmustbeprotectedatalltimeswheninstallingandremovingthebasestand.Besurethatnohardorsharpobject,
oranythingthatcouldscratchordamagetheLCDdisplay,comesintocontactwithit.DONOTexertpressureonthefrontoftheTVatanytimebecause
thescreencouldcrack.
PleaseinspectyourTVfordamageafterunpacking.Ifyoudonoticeanydamagepleaseconsultyourdealer.
Removeallpackagingfromtheunit.Retainthepackaging.Ifyoudisposeofitpleasedosoaccordingtoanylocalregulations.
 TV
 TVStand
 RemoteControl/
AAABatteriesx2
 Screwsx4
 FAVCable
 InstructionManual
 QuickStartGuide
Unpacking
1
1. ConnectoneendoftheRFcoaxialcabletotheaerialsocketonthewall
andtheotherendofthecabletotheANTsocketonthebackofyourTV.
2. PlugtheTVintoamainssocketandswitchonatthemains.
3. Instandbymode,pressthe
buttonontheremotecontroltoturnthe
TVon.TheLEDindicatorwillashforafewsecondsthentheTVwill
switchon.
Connecting the Aerial and Turning on the TV
4
Fitting the Stand to the TV
1. EnsuretheTVisswitchedoandnotconnectedtothemainspowersupply.
2. LaytheTVdownonaatsurfaceideallyontheedgeofatablesothebaseoftheTVslightlyoverhangstheedgeofthetable,withtheback
sidefacingup.Pleasemakesureasoftcushionedmaterial(suchasadrybathtowelorthickpieceoffoam)isplacedbeneaththescreen.
3. Slidethestandunderthelip,theneckwilltsnuglyoverthescrewholes.ThenscrewthestandtotheTVusingthe4screwssupplied.
Installing the Base Stand
3
1. Slideopenthebatterycompartmentonthebackoftheremotecontrol.
Operating Your Remote Control
2
Thank youforpurchasingyournewJVCTV.
YournewTVincorporatesthelatesttechnologytoenhanceyourviewing
experience.Wewouldsuggestthatyouallowabout20minsforinitialsetup.
Pleasefollowthisguideforasuccessfulrsttimeinstallation.
Thelatesteco-friendlypower-savingtechnologywillswitchotheTVif
itisleftonandidlefor4hours.Pleasereferto“AutoStandby”underthe
“TimeSettings”sectionoftheinstructionmanualformoredetail.
Quick Start Guide
32" LED Smart HD TV
LT-32C650(A)
Slide under
the lip
Slide under
the lip
SCART
SPDIF
Optic.OUT
VGA
ANT.
HDMI 1
(ARC)
HDMI 2 HDMI 3
LAN
Table
Cushioned
material
2. InserttwoAAAsizebatteries.Makesuretomatchthe(+)and(-)
endsofthebatterieswiththe(+)and(-)endsindicatedinthebattery
compartment.
3. Slidethebatterycompartmentcoverbackintoplace.Makesureitclicks
intoplace.
Optional
Ifyouwanttoconnecttotheinternetviaawiredconnection
thenconnectyourethernetcabletotheLANsocket.
SCART
SPDIF
Coax.OUT
VGA
ANT.
HDMI 1(ARC)
HDMI 2
LAN
SCART
SPDIF
Coax.OUT
VGA
ANT.
HDMI 1
(ARC)
HDMI 2
LAN
RF coaxial cable
(not included)

JVC LT-32C655B Specifications

General

Brand	JVC
Model	LT-32C655B
Category	Smart TV
Language	English