32
Maintenance
Timing of replacing the lamp
When the Lamp indicator lights up red or a message appears suggesting it is time to replace the
lamp, please install a new lamp or consult your dealer. An old lamp may cause a malfunction in
the projector and in some instances the lamp may explode.
The LAMP indicator light and TEMP warning light will light up if the lamp becomes too hot. Turn
the power off and let the projector cool for 45 minutes. If the LAMP or TEMP indicator still lights
up after turning the power back on, please contact your dealer. See "Indicators" for details.
The following lamp warning displays will remind you to change the lamp.
The illustrations show below are for reference only and may differ from the actual design.
Status Message
The lamp has been in operation for 3500 hours. Install a
new lamp for optimal performance. If the projector is
normally run with Eco selected (See "Getting to know the
lamp hour"), you may continue to operate the projector until
the 3950 hour lamp warning appears.
The lamp has been in operation for 3950 hours. A new lamp
should be fitted to avoid the inconvenience when the
projector runs out of lamp time.
The lamp has been in operation for 4000 hours.
It is strongly recommended that you replace the lamp at this
age.
The lamp is a consumable item. The lamp brightness
diminishes with use. This is normal lamp behavior. You
can replace the lamp whenever you notice that the
brightness level has significantly diminished. If the
lamp is not replaced beforehand, it must be replaced
after 4000 hours usage.
The lamp MUST be replaced before the projector will
operate normally.
To Next Page
Loading...
Need help?
General
