Playing back sources from external devices
18
■ IMPORTANT
• Slide the remote control mode
selector to [AUDIO].
1 Press [AUDIO IN] or [DIGITAL IN].
• Pressing [AUDIO IN] displays “AUDIO IN”
and selects the device connected to the
[AUDIO IN] terminals.
• Pressing [DIGITAL IN] displays “DGTL IN”
and selects the device connected to the
[DIGITAL IN] terminal.
• You can also select the connected device as
the source by repeatedly pressing
[SOURCE] on the main unit.
2 Start playback on the connected
device.
3 Adjust the volume or the sound
quality for your preference.
• Refer to page 12.
NOTE
• Refer also to the operation manual for the con-
nected device.
•
You can also operate your digital broadcast satel-
lite and video cassette recorder using the remote
control of this system. Refer to pages 48-50.
You can select the gain of the signal from the
[AUDIO IN] terminals. Use the initial settings for
normal operation. If the sound is too small or too
loud, change the settings.
1 Press [AUDIO IN].
• “AUDIO IN” appears in the display window.
2 Hold down [ENTER].
• “LEVEL 1” or “LEVEL 2” appears in the dis-
play window.
3 Press [ENTER] repeatedly to
select “LEVEL 1” or “LEVEL 2”.
• Each time you press [ENTER], the display
toggles between “LEVEL 1” and “LEVEL 2”.
• The signal gain in “LEVEL 1” is lower than
that in “LEVEL 2”.
• The display returns to “AUDIO IN” in approx-
imately 5 seconds.
Remote control
mode selector
Playing back sources from
external devices
Selecting the signal gain
Playing back sources from external devices
NX-F3_NX-F7[A]EN.book Page 18 Tuesday, April 22, 2008 1:55 PM
To Next Page
Loading...
Need help?
General
