JVC QL-A2 Service Manual

Tonearm Section
Adjustment
The following adjustments should be performed only when
replacing a cartridge or a headshell.
Otherwise, no adjustment is required.
Note: If necessary to replace a cartridge, usage of that
headshell exclusive to this unit is recommended.
9-(3) Overhang Adjustment
Loosen the stylus mounting screws and slide the cartridge
to adjust the stylus tip position so that tip is coming just
over the overhang indicator. (See Fig. 18.)
Overhang indicator
9-(4) Tonearm Lifter Height
Adjustment
Adjust the height of tonearm lifter with the adjustment “ah
screw so that the distance between the stylus tip and the Fo
surface of record is about 6 mm when the stylus is elevated.
Turn the height adjustment screw clockwise to lower, and
counterclockwise to raise the tonearm lifter level. (See Fig.
19.)
9-(5) Auto-return (Lead-out) Adjustment
When the pulley has been replaced for a different record or Pick-up Shaft
if auto-return functions early, adjust as shown in Fig. 20.
— When change cycle starts too late, turn the screw
counterclockwise with a screwdriver.
— When change cycle starts too early, turn the screw
clockwise.
Driver
Adjustment Screw
Trip Slide
OL-A2
No.
2444
=i:
Fig. 18
Adjustment screw
Fig, 19
Fig. 20

JVC QL-A2 Specifications

General

Brand	JVC
Model	QL-A2
Category	Turntable
Language	English