2. HO DAMPING knob
This controls the horizontal movement of the tonearm
while aiding to keep the tonearm's resonating point low.
Set the knob to the same indication number as the
optimum tracking force of this unit.
3. VQ DAMPING knob
This controls the vertical movement of the tonearm while
aiding to keep the tonearm's resonating point low. Set the
knob to the same indication number as the optimum
tracking force of this unit.
4. Speed select knob
Select a proper position of the speed select knob in
accorda ~ c .th the rpm of the record.
33- 73rpmrecord (LP) "33"
rpmrecord(EP) "45"
5. QUARTZ LOCK/PITCH CONTROL select button
QUARTZ LOCK:
Depress the button to the QUARTZ LOCK position (.-.)
for playing a record at an accurate rotation speed in the
quartz lock mode. In this case, the meter lights green.
PITCH CONTROL:
Depress the button a second time to obtain the PITCH
CONTROL position (-) in order to perform fine pitch
adjustment for the sound meeting your preference. In
this case, the meter lights orange.
6. PITCH CONTROL meter
When the QUARTZ LOCK/PITCH CONTROL select
button is set to the QUARTZ LOCK position, the meter is
green-Iit and the indicator displays "0".
When the QUARTZ LOCK/PITCH CONTROL select
button is set .to the PITCH CONT RO L position, pitch
control can be performed by turning the PITCH CON-
TROL knob and the meter is orange-lit.
#6 % means +6 %
b6% means -6 %
7. PITCH CONTROL knob
Fine pitch control can be performed with the QUARTZ
LOCK/ PITCH CONTROL select button set to the PITCH
CONTROL position. Pitch adjustment range is !6 %. The
indicator in the meter deflecting to the left (#) from the
center(O) indicates an increase to the accurate 33-1/3 or
45 rpm and the deflection to the right (b) means a de-
crease.
8. ANTI-SKATING knob
This device cancels out the centripetal force that pulls
the tonearm to the center of the platter. Th is prevents the
stylus tip from skating toward the center of the platter
and at the same time eliminates any excessive stylus tip
force on the inner wall of the record groove. Use the 8
marked dial when employing a spherical stylus. Use the
.marked dial when employing an elliptical stylus or
a SHIBATA stylus.
Turn the dial to the same number as on the tracking force
dial.
9. REPEAT knob
Decide how many times you want to re-Iisten to the re-
cord by using this knob. When you set the knob to "R",
the record will continue to play repeatedly.
Note: This knob cannot be turned to indicate from 1 -0
or 0 -1 if the ST ART button is depressed with
the power cord disconnected from the outlet. For
this, refer to the note in the section "Necessary
procedures prior to record playing" onpage 5.
10. START/REJECT buttons
When you start playing a record, depress the ST ART
button. The tonearm moves automatically to the position
of the first groove of the record pre-selected and gently
lowers itself onto the surface of the record to play it.
When you stop playing the record, depress the REJE'CT
button. The tonearm lifts, returns automatically to its
rest and the platter stops rotating.
If, however, the REPEAT knob has been set for a number
of repeats.. the tonearm performs the corresponding
number of prepeats before the platter stops rotating.
Note: When the dial of the repeat knob has been set to
numbers other than "0", the platter continues to
rotate and the power will not be turned off even
though you depress the R EJ ECT button or even
if the playing record has finished. When you want
the power to be turned off after the record has
played once, be sure to set the repeat knob to the
"0" mark.
11. RECORD SIZE select knob
Set the knob to the corresponding position to the size
of the record before you play it.
30 cm diameter record. "30" (12'1
25 cm diameter record. "25" ( 10")
17cmdiameterrecord "17"(7'1
12. Arm lifter lever
This is used when you want to raise the tonearm gently
or gently lower it. When you push it to the "UP" position,
the tonearm will be lifted up, and when you pull it to the
"DOWN" position, it will be lowered down gently onto
the record surface.
_.1-
To Next Page
Loading...
Need help?
General
