EN
CARE OF CASSETTE MECHANISM
Gently clean the tape head and pinch wheel/capstan assemblies after every 10 hours of using
the unit. A range of cassette care products are available.
1. Pinch Roller
2. Capstan
3. Record/Playback head
4. Erase Head
The erase head and record/play head and the surface of the pinch roller are delicate and must
not be touched with metal objects such as screwdrivers. You may nd it easier to clean the
assembly by pressing the PLAY button to bright head and pinch roller into view. Be sure to
press the STOP/EJ. button after cleaning the mechanism.
Damage to the pinch wheel can occur if the unit is left in PLAY mode with the power switch o.
Under no circumstances should you attempt to lubricate any part of the machine.
CD/MP3 OPERATION
Discs for Playback
This system can playback all digital audio CD, MP3, nalized digital audio CD-Recordable (CD-
R) discs, nalized digital audio CD-Rewritable (CD-RW) discs and CD-DA format digital audio
CD/CD-R/CD-RW discs.
LOADING A DISC
1. Press the /FUNC. button to choose CD mode.
2. Open the CD door. “OP” will be shown on the display.
3. Place an audio CD into the tray with the label side facing up.
4. Close the CD door. The total number of tracks will appear on the display after reading
finished.
5. To remove the CD, press /STOP button and open CD compartment lid, grasp the CD by
its edges, and carefully take it out.
Note:
To ensure good system performance; wait until the disc tray completely reads the disc before proceeding.
If no disc is loaded into the compartment, or the disc is placed upside down, the display will show “N0“.
PLAYING A DISC
1. After loading the disc, the unit starts playback automatically.
2. To interrupt playback, press the /SCAN/PAIR button. The “ ” indicator will flash on the
display. To resume playback, press the /SCAN/PAIR button again.
3. To stop playback, press the /STOP button, the total number of tracks appears
on the display.
SELECTING A DESIRED TRACK/PASSAGE
To select a desired track
• Press the /TUN+ or /TUN- button repeatedly in stop mode or during play until the desi-
red track appears on the display.
• Press the /SCAN/PAIR button to start play.
To search for a particular passage during playback (track scanning at high speed)
Press and hold the /TUN+ or /TUN- button to scan the current playing track at high speed
until desired passage appears, and then release the button. Playback will start again from this
point.
To Next Page
Loading...
Need help?
General
