JVC RX-5052S User Manual

5
CENTER
SPEAKER
SURROUND
SPEAKERS
RIGHT
LEFT
FRONT
SPEAKERS
RIGHT
LEFT
CAUTION :
SPEAKER IMPEDANCE
8
16
—
+
–
+
–
To center speaker
To right front speaker
To right surround speaker
To left surround
speaker
To left
front speaker
AM
LOOP
AM
EXT
ANTENNA
COAXIAL
FM 75
1
2
3
4
AM (MW) antenna connections
Turn the loop until you have the best reception.
Notes:
• If the AM (MW) loop antenna wire is covered with
vinyl, remove the vinyl by twisting it as illustrated.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord.
This could cause poor reception.
• If reception is poor, connect an outdoor single vinyl-covered wire
(not supplied) to the AM EXT terminal. (Keep the AM (MW) loop
antenna connected.)
AM (MW) Loop
Antenna (supplied)
Outdoor single vinyl-covered wire (not supplied)
Snap the tabs on the loop into
the slots of the base to
assemble the AM (MW) loop
antenna.
1
23
Connecting the Speakers and Subwoofer
You can connect five speakers (a pair of front speakers, a center
speaker, and a pair of surround speakers) and a subwoofer.
CAUTIONS:
• Use only the speakers of the SPEAKER IMPEDANCE
indicated by the speaker terminals.
• Do not connect more than one speaker to each speaker
terminal.
Connecting the speakers
1 Twist and remove the insulation at the end of
each speaker cord.
2 Press and hold the clamp of the speaker terminal.
3 Insert the speaker cord.
4 Release the finger from the clamp.
For each speaker (except for a subwoofer), connect the (+) and
(–) terminals on the rear panel to the (+) and (–) terminals
marked on the speakers.
RIGHT
LEFT
+
–
RIGHT
LEFT
+
–
Do not connect the AC power cord until all other connections
have been made.
RIGHT
LEFT
+
–
01-08_5052[B]3.p65 04.12.7, 1:23 PM5

JVC RX-5052S Specifications

General

Brand	JVC
Model	RX-5052S
Category	Receiver
Language	English