Page 17
Using Visual Confirmation
When you operate the receiver, you can see what you are doing, by showing it on the TV screen.
To use this function, you need to connect the TV to the MONITOR OUT jack on the rear panel (see page 9),
and set the TV’s input mode to the proper position to which the receiver is connected.
When the TV’s input mode is for TV, you cannot see the on-screen display.
On the front panel only:
1. Press SETTING so that the Control
%%
%%
% /
fifi
fifi
fi /
@@
@@
@ /
##
##
# buttons work for setting Visual
Confirmation.
The lamp next to the button lights up.
2. Press Control
%%
%%
% /
fifi
fifi
fi until “VCONFIRM” appears on the display.
3. Press Control
@@
@@
@ /
##
##
# to set Visual Confirmation to “ON” or “OFF.”
• Select “ON ” to activate Visual Confirmation.
The VISUAL CONFIRMATION indicator lights up on the display.
• Select “OFF” to cancel it.
The indicator goes off.
EXAMPLES:
When changing the source:
When adjusting the front speaker output balance:
When selecting your favorite SEA mode:
MENU
See also
page 32.
The SOURCE menu appears on the TV screen for
about 5 seconds.
SETTING
Front panel
The SETTING menu appears on the TV screen for
about 5 seconds.
The SEA MODE menu appears on the TV screen for
about 5 seconds.
RX-772VBK[J]_0052-001A.En.01-23 97.4.8, 3:24 PM17
To Next Page
Loading...
Need help?
General
