30
To turn off the power (into standby mode),
press
(STANDBY/ON) again.
The STANDBY lamp lights up, and the front
door automatically closes. (The ZONE 1 ON/
OFF and/or ZONE 2 ON/OFF lamp goes off.)
• A small amount of power is consumed in standby mode. To turn
the power off completely, unplug the AC power cord.
From the remote control:
1. Set ZONE 1/ZONE 2 (LEARN/
TRANSMIT) selector to “ZONE 2.”
Now the buttons and controls on the remote
control work for Zone 2 operations.
2. Press AUDIO (ON).
The STANDBY lamp on the unit goes off, and the ZONE 2 ON/
OFF lamp on the unit lights up.
• When connecting the Zone 2 front speakers to the FRONT 2/
ZONE 2 SPEAKERS terminal, see also “w Setting the Zone
2/Speakers 2 Usage—ZONE 2/SPEAKER 2” on page 43, and
“Activating the Zone 2 Front Speakers” on page 32.
To turn off the power (into standby mode),
press AUDIO
(STANDBY).
The STANDBY lamp lights up, and the front
door automatically closes. (The ZONE 1 ON/
OFF and/or ZONE 2 ON/OFF lamp on the unit
goes off.)
Note:
If you have turned off the receiver with the volume level set at more
than level “–35 dB,” the volume level will be automatically set at level
“–35 dB” next time you turn on the receiver.
Canceling the Zone 2 Operations
On the unit:
To stop Zone 2 operations and sounds through the
Zone 2 speakers, press ZONE 2 ON/OFF so that the
ZONE 2 ON/OFF lamp goes off.
No sound will be heard in Zone 2, and the display
changes to show the Zone 1 source.
To use this receiver for Zone 2 operations again
1. Press ZONE 2 ON/OFF again so that the
ZONE 2 ON/OFF lamp lights up.
2. Press ZONE 2 CONTROL (inside the front
door).
The name of the current source for Zone 2
appears on the display.
From the remote control:
To stop Zone 2 operations and sounds through the
Zone 2 speakers, press ZONE 2 ON/OFF so that the
ZONE 2 ON/OFF lamp on the unit goes off.
To use this receiver for Zone 2 operations
again, press ZONE 2 ON/OFF again.
Notes:
• If you have turned off Zone 2 with the volume level set at more than
level “–35 dB,” the volume level will be automatically set at level
“–35 dB” next time you turn on Zone 2.
• If “TURN ON ZONE1 OR ZONE2” appears on the display, press
ZONE 1 ON/OFF or ZONE 2 ON/OFF to listen to the sound in
Zone 1 or in Zone 2; otherwise, the receiver will turn off after about
1 minute.
STANDBY/ON
STANDBY
ZONE 2
ON/OFF
SPEAKERS
VOLUME
ZONE 2
1
dB
dB
L
ANALOG
SPEAKERS
VOLUME
1
SUBWFR
R
dB
ZONE 2
ON/OFF
ZONE 2
CONTROL
SPEAKERS
VOLUME
ZONE 2
1
dB
dB
ON/OFF
ZONE 2
ZONE 2
TRANSMITLEARN
ZONE 1
ZONE 2
ON/OFF
STANDBY
ON
STANDBY
ON
19-32_RX-DP15B[J]f.pm6 04.3.15, 9:23 PM30
To Next Page
Loading...
Need help?
General
