– 3 –
Operating the Unit Automatically According to the Incoming
Signals—AUTO POWER ON/STANDBY
To activate AUTO POWER ON/STANDBY.
Press the AUTO POWER ON/STANDBY switch to the [ ] ON
position.
• If no sound comes in for 5-10 minutes, the unit enters
standby mode. The power lamp lights in red.
• If the unit detects incoming signals, the unit starts
operating. The power lamp lights in green.
To cancel AUTO POWER ON/STANDBY.
Press out the AUTO POWER ON/STANDBY switch to set it to the
[
] CANCEL position.
CANCEL
ON
AUTO POWER ON / STANDBY
When the volume level of the amplifier is so low or the
incoming signals are so weak that this unit cannot detect
sounds, Auto Power On/Standby may not work correctly.
Turning On the Power—POWER
To turn on the power.
Press the POWER switch to the [ ❙ ] ON position.
• The power lamp lights in green.
To cut of the power.
Press the POWER switch to the [ ‡ ] OFF position.
• The power lamp goes out.
• This will disconnect the mains lead.
Operations
Front Rear
Power lamp
Connections
Before connecting this unit to the amplifier (or receiver), observe
the following carefully.
• Turn off the amplifier.
• Make all connections before plugging in this unit.
• DO NOT connect this unit to the REC OUT jacks of your
amplifier. It may damage your subwoofer.
Amplifier or Receiver
To LINE OUT
To SUBWOOFER OUT
or MONO
Stereo audio cord (not Supplied)
In the case that the receiver dose not have the SUBWOOFER OUT or MONO terminal.
Monaural audio cord (Supplied)
To an AC outlet
To Next Page
Loading...
Need help?
General
