Basicoperations I See page 18 for button locations. I
NOTE
• Whenyou change the positioning of the speakers or listener, or
replace the supplied speakers with other nnes. perform Smart
Surround Setup again.
• While DVD is selected as the source and stopped
I Take your position where you listen to
the sound.
2 Press and hold SMART S.SETUP.
When "FAILED !" appears on the TV screen
The system Collld not detect the clapping sound correctly. In Sllch a
case, follow the instructions that appears on the TV screen.
• Whenthesystemdetectstheclappingsoundas"FAILED !"three
times, set the distance (DISTANCE) and the outpnt level
(LEVEL) manually C -"pg. 39).
To cancel
Press SMART S.SETUP.
NOTE
• You need to set tile subwnnler's output level (LEVEL) manually.
(v pg. 20 or 39)
• In step 2, "SW ERROR" appears on the display window if the center
unit and the powered subwooler are not c(mnected correctly by using
the supplied system cnrd.
"SETTING UP" flashes on the display window.
3 Press ENTER, press Cursor T/A to
select the distance between the front
speakers and the listening position,
then press ENTER.
4 Press Cursor _,/A to select START,
then press ENTER.
5 Clap your hands over your head once.
6 Make sure that "COMPLETED !"
appears on the TV screen, then press
SMART S.SETUP.
Tile system detects your clapping sound through the satellite
speakers, then automatically makes the best settings for each
speaker. "COMPLETED !" appears on the TV screen when
Smart Surround Setup completes.
21
To Next Page
Loading...
Need help?
General
