8
Listening to the Radio
To select the band (FM/AM)
To tune in to a station
While FM or AM is selected...
Frequency starts changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency search stops.
• When you repeatedly press the button, the frequency
changes step by step.
To stop searching manually,
press either button.
If the FM station has poor reception
To preset stations
You can preset 30 FM and 15 AM stations.
• To cancel the operation during procedure, press CANCEL.
1
Tune in to a station you want to preset.
• You can also store the monaural reception mode for FM
preset stations if selected.
2
Start presetting.
3
Select a preset number.
4
Store the station.
To tune in to a preset station
1
Select the band (FM or AM).
2
Select a preset number.
The MONO indicator lights on the
display. Reception will improve though
stereo effect is lost—monaural reception
mode.
To restore the stereo effect,
press the
button again (the MONO indicator goes
off).
INFO
FM/AM
FM AM
1
sec.
Increases the frequencies.
Decreases the frequencies.
Remote
ONLY
FM MODE
Remote
ONLY
SET
Examples:
To select preset number 5, press 5.
To select preset number 15, press +10,
then 5.
To select preset number 30, press +10,
+10, then 10.
• You can also use +/– buttons.
Examples:
To select preset number 5, press 5.
To select preset number 15, press
+10, then 5.
To select preset number 30, press
+10, +10, then 10.
• You can also use 4
/¢
buttons on the remote control or
PRESET +/– buttons on the main
unit.
123
456
789
10 0 +10
FM/AM
FM AM
123
456
789
10 0 +10
DX_T9[J].book Page 8 Tuesday, December 13, 2005 1:53 PM
To Next Page
Loading...
Need help?
General
