JVC UX-A5 User Manual

UX-A5 A/B/E/G/GI/EN
2}
Key
Points
for
Safety
Control
of
Model
UX-A5 B/E/G
CD P.C. board
1€503°
Power P.C. board and
power transformer
1. Check ‘‘VTP66T6-24A =B, VTP66J6-24A =E/G” of
power transformer and make sure that any bolt is not
loosened.
2. Check the power source cord indication ‘’ <VDEp> /E,G,
BASEC.BS6500/B version’’ of attachment plug
“KP-419C"’, and make sure that the cord is free from
any defect (damage).
3. The primary circuit of the P.C. board and the pattern
contacting the circuit should be extrusion-soldered by as
much as one round to acquire a creeping distance.
* Any back-mounted parts of the P.C. board should be
fixed with a spacer or bond.
5. Since the following parts are exothermic, make sure that
such parts will not come into contact with any electrolytic
capacitor/condenser, wire and other parts:
CD block: The IC306, heat sink and transistors (Q901,
Q902, 903, D901 and IC503) are exothermic
parts.
1F (Function P.C. board)
Tuner P.C. board
Fig. 2-1
Deck block: The diode (D951), IC351, heat sink and
transistor (Q801) are exothermic parts.
6. Any wire, etc. should be clamped or bonded as indicated
in the above diagram so that such wire will not be posi-
tioned close to any exothermic parts.
7. The 10PIN wire of the tuner P.C. board should be treated
by drawing it out to the tuner P.C. board side after
inserting the connector in order that the wire will not
approach close to any exothermic parts.
8. By using the special tool, attach the power cord bushing
to the position where ‘‘4N-4”’ is marked.
9. Set and firmly fix the fuses F951, F953 and F954
respectively to T630mA T1.6A and T630 after confirm-
ing the respective positions.
Other
A barrier should be provided between the transformer
connector and jack holder.

JVC UX-A5 Specifications

General

Brand	JVC
Model	UX-A5
Category	Speakers
Language	English