JVC UX-C7 User Manual

UX-C7 B/E/G/GI/EN |
( CLOCK/TIMER ADJUSTMENT
(Using the remote control)
Names of parts in the clock/time section, and their
functions:
LE
SHIFT button
Botén SHIFT
Touche SHIFT
© Timer mode indicator
@ Timer indicator (ON/OFF)
© SLEEP indicator
O CLOCK indicator
© Time display
@ SLEEP button
Press the following buttons while holding down the SHIFT
button.
@ TIMER ( © ) button
© CLOCK button
© DOWNUP button
@ ENTER button
® Timer ( © ) ON/OFF button
20 (No. 1898)
Setting the current time
(when the UX-C7 is used for the first time)
(Example: to set the clock to PM 1:15.)
O)
- (ocw)-
~~
C> c> —AM bei ti-
SHIFT CLOCK ) / Y - ‘Y X
SHIFT
>=)
E>
in
if
i:
@ Connect the AC power cord; "CLOCK" will blink in the
display.
@ Press the CLOCK button while pressing the SHIFT
button; "AM 12:00" will blink in the display.
@® Set to PM 1:15 by pressing the UP/DOWN buttons while
pressing the SHIFT button. (When the buttons are kept
pressed, the minute/hour indication changes
continuously.)
@® Press the ENTER button while pressing the SHIFT
button; the time will light in the display.
@ Each time the hour's digits change from 11 to 12, the
display alternates between AM and PM, ( 12 midnight is
indicted as "AM 12:00" and 12 noon is indicated as "PM
12:00".)
® To set to the nearest second...
Press the ENTER button while pressing the SHIFT
button when you hear the time signal from a TV or radio.
Notes:
© Before performing timer recording or playback, it is
necessary to set the current time.
@ It is recommended to set the current time with the power
switch set to STANDBY so that the current display mode
is maintained.
@ When the power cord is plugged in again after being
disconnected or power is restored after a power failure,
"CLOCK" will blink in the display. Set the current time
again.
Vir
fal

JVC UX-C7 Specifications

General

Brand	JVC
Model	UX-C7
Category	Stereo System
Language	English