3
English
CAUTION: Make all connections before plugging the System into an AC power outlet.
Rear Panel of the Unit
Using the Supplied Wire Antenna
Using the Coaxial Type Connector (Not Supplied)
A 75-ohm antenna with coaxial type connector (IEC or DIN45 325)
should be connected to the FM 75-ohm COAXIAL terminal.
If reception is poor, connect the outdoor antenna.
Note: Before attaching a 75 ohm coaxial lead (the kind with a
round wire going to an outdoor antenna), disconnect the
supplied FM Wire Antenna.
Rear Panel of the Unit
CAUTION: To avoid noise, keep antennas away
from the System, the connecting cord and the AC
power cord.
Connecting the FM Antenna
L
OPTICAL
DIGITAL OUT
L
R
R
FM wire antenna (supplied)
Coaxial cable
FM outdoor antenna
(Not supplied)
Connecting the AM (MW/LW) Antenna
L
OPTICAL
DIGITAL OUT
L
R
R
Attach the AM loop to its base by snapping the tabs on the
loop into the slot in the base.
AM loop antenna (Supplied)
AM EXT
AM LOOP
FM (75Ω)
COAXIAL
ANTENNA
Turn the loop until you have the best reception.
01 UX-V55R(E)-eng.fm Page 3 Friday, June 11, 1999 11:33 AM
To Next Page
Loading...
Need help?
General
