7
Replacing and cleaning the filter
cartridge
• Release the container clips, lift off the
vacuuming assembly, and lay it on its side.
• Undo the bayonet catch holding the filter
cartridge in place (Illustration D).
• Pull filter off, and clean with a soft brush.
It can also be rinsed under running water
(Illustration E). Allow the filter to dry out
before the cleaner is used for dry-vacuuming
again.
• Place the vacuum assembly onto the
container, and secure with the clips.
Technical specifications
..................................................... 1.085-281
..................................................... 1.085-601
Voltage 240 V
1~50/60 Hz
Mains fuse (slow) 12 A
Container volume, net 18 L
Water intake capacity 8 L
Blower data P
MAX
1200 W
P
NOM
1000 W
Air flow rate 55 L/sec
Vacuum 175 mbar
Weight 6 kg
Class of protection II
Mains cable Type H05VV-F2x1
Sound pressure level 74 dB(A)
Specifications subject to change without prior
notice.
K 2201 English
Wet-vacuuming
Never use this cleaner to vacuum explosive
liquids, acids or solvents.
• The paper filter bag must be removed before
using the cleaner for wet-vacuuming.
• The filter cartridge can remain in the unit. It
must however be allowed to dry out before the
cleaner is used for dry-vacuuming again.
• If the container is full, the float closes the inlet,
the suction power is reduced, and the suction
motor runs at a higher speed. When this
happens, switch off and unplug the cleaner
from the mains electricity.
• Hold the hose up high to allow any liquid to
flow into the container.
• Cleaning can be continued as soon as the
container has been emptied.
Emptying the container
• Release the container clips, lift off the
vacuuming assembly, and lay it on its side.
• Within a short period of time wet dirt will start
to decay, therefore empty the container after
each use, and rinse it out with clean water.
Problem Cause Remedy
Motor (suction turbine) does not
work
No power supply Check building fuse, mains cable
and socket.
Suction power drops off gradually Blocked filter cartridge, nozzle,
suction hose or tube
Check, clean
Suction power drops off suddenly Full paper filter bag or container Switch off unit, and empty
container. Replace filter bag.
Dust is expelled during
vacuuming
Defective or improperly fitted filter
cartridge
Check filter fitting; replace filter
cartridge if required
Troubleshooting
To Next Page
Loading...
Need help?
General
