English 9
Detergents can only be applied at
low pressure setting (Mix) or with
the Wash Brush.
Î STEP 1:
Install the Vario Power Spray
Wand. Set the spray wand to the
low pressure setting (Mix).
OR
Install the Wash Brush.
Î STEP 2:
One Gallon Ready to Use Instruc-
tions:
Fill a container with Kärcher deter-
gent. Place the filter end of deter-
gent suction tube into the container.
Kärcher SoapPac Instructions:
Kärcher SoapPacs are designed to
completely dissolve in water. A Kär-
cher SoapPac Sample of Concen-
trated Vehicle Wash & Wax is
included with your pressure was-
her. This product is packaged in
self dissolving film that is formula-
ted to quickly remove dirt, grease
and grime, while leaving the sur-
face film-free. It provides a just-wa-
xed look in one simple product
Do not cut or tear open the
Kärcher SoapPac. Do not handle
with wet hands. Avoid contact
with skin, eyes and mucous
membranes. May cause irrita-
tion. Harmful if swallowed. Mix
only with water. DO NOT mix with
other chemicals or cleaning
agents.
– Insert one SoapPac into a bucket.
– Fill the bucket with cool or warm
water (1/4 gal/1 qt /1 L).
– Agitate water in the bucket and wait
for product to completely dissolve.
– Place the filter end of detergent
suction tube into the container.
– Apply detergent on low pressure
setting OR with the Wash Brush.
For other Kärcher SoapPac Deter-
gents, check your retailer or visit
our website: www.karcher-
usa.com/home or www.karcher-ca-
nada.com for more information.
WORKING WITH DETERGENTS
To Next Page
Loading...
Need help?
General
