Kärcher K 2 Plus User Manual

10 English
몇 CAUTION
When disconnecting the supply or high-
pressure hose, warm water may leak
from the connector after operation.
 STEP 6:
Push the housing of the quick con-
nect toward the rear and disconnect
the high-pressure hose from the unit.
1 Disconnect all water connections.
2 Turn on the machine for a few sec-
onds, until the water which had re-
mained in the pump exits, turn off
immediately.
3 Do not allow high-pressure hose to
become kinked.
4 Store the machine and accessories
in a room which does not reach
freezing temperatures. DO NOT
store near furnace or other sources
of heat as it may dry out the pump
seals.
몇 CAUTION
Failure to follow the above directions will
result in damage to the pump assembly
and accessories and will void the war-
ranty.
Kärcher
®
also recommends the regular
practice of using a pump protector like
“Kärcher
®
Pump Guard” to prevent cold
weather damage during storage in the
winter months.
 STEP 1:
Disconect the connector from the
water inlet.
 STEP 2:
Pull out water inlet filter with flat-nose
pliers.
 STEP 3:
Rinse out water inlet filter in warm
water.
 STEP 4:
Reinsert water inlet filter into the wa-
ter inlet.
The unit is maintenance-free.
WINTERIZING AND LONG-
TERM STORAGE
CARE AND MAINTENANCE
INSTRUCTIONS
Cleaning the water inlet filter
Maintenance

Kärcher K 2 Plus Specifications

General

Brand	Kärcher
Model	K 2 Plus
Category	Pressure Washer
Language	English