Kärcher SCP 6000 Instruction Manual

– 3
1 Power cord with plug
2 Level sensor
3 Level sensor stopper
4 Carrying handle
5 Hose connection 1" (25.4 mm)
Illustration
 Screw the hose connection on to the
pump
Note
The shorter the hose, the higher the feed
rate.
 Push the hose on the hose connection
and fasten it with appropriate hose clip
Illustration
 In automatic operations mode, set the
required switching height by clamping
the level sensor cable in the stopper.
Illustration
 In manual operations mode, align the
level sensor upward (cable pointing
downward). Tip: Push the cable of the
level sensor like a loop through the han-
dle.
Illustration
 Place the pump on a level, stabile sur-
face in the liquid to be transported, en-
sure that it is standing firmly or immerse
it using a rope tied to the handle.
The suction area should not be blocked
fully or partially through the impurities.
The liquid level must at least be 3 cm (SCP
6000 / 7000) and 8 cm (SDP 7000) for the
pump to suck in liquids independently.
 Insert the mains plug into the socket.
In the automatic mode, the level switch au-
tomatically controls the pumping opera-
tions. The pump switches on or off when
the fluid level reaches the height that has
been set.
Ensure that the level sensor is not obstruct-
ed in any way.
In manual opertions the pump remains
switched on continuously.
Note:
Dry run leads to increased wear and tear;
do not leave the pump unattended when it
is running. Switch off the pump within 3
minutes of dry running.
 Rinse the pump with clean water after
use.
Note
Contaminations can accumulate and lead
to malfunctions.
 Disconnect the main plug from the
socket.
The appliance is maintenance-free.
Start up
Description of the Appliance
Preparing the Appliance
Operation
Automatic operation
Manual operation
Finish operation
Maintenance and Care
Maintenance
13EN

Kärcher SCP 6000 Specifications

General

Brand	Kärcher
Model	SCP 6000
Category	Water Pump
Language	English