– 7
Remove the wiping cover from the
spray bottle and rinse it under run-
ning water. The wiping cover can
also be washed in the washing ma-
chine at a temperature of up to
60°C (without the use of fabric sof-
teners).
Let the cleaned appliance dry prior
to assembly.
Charge the battery.
Store the appliance upright in a dry
room.
Refill detergent.
Pump mechanism in spray botte
defective, contact dealer.
Check the charge/operations display:
No signal or slowly blinking signal:
Charge the battery.
With a rapidly blinking signal: In-
form your dealer.
Clean the pull-off lip.
Reverse the used pull-off lip:
Pull the silicone squeegee to the
side. Wet the squeegee in the area
of the curve with water or detergent.
Slide the silicone squeegee back in
the holder in reverse order.
Replace the pull-off lip if neces-
sary:
If both edges are worn after turning
the silicone squeegee around, a
new silicone squeegee is required.
Replace silicone squeegee as de-
scribed above.
Adjust the dosing of cleaning solution.
Empty the dirt water reservoir (max.
100 ml content).
Window cleaner concentrate
(4 x 20 ml)
Order No. 6.295-302.0
Micro-fibre wiping pad (2 piece)
Order No. 2.633-100.0
Removable lips, wide (2 ea.)
Order No.: 2.633-005.0
Removable lips, small (2 ea.)
Order No.: 2.633-104.0
Waist bag
Order No.: 2.633-006.0
Subject to technical modifications!
Storing the Appliance
Troubleshooting
Spray bottle does not spray
Machine does not start
Streaks while cleaning
Water is leaking from the side
of the tank
Special accessories
Technical specifications
Type of protection IP X4
Volume of dirt water res-
ervoir
100 ml
Operating time with full
charge
25 min
Nominal battery voltage 3,7 V
Rated power of appli-
ance
10 W
Charging current for
empty battery
140 min
Output voltage, charger 5,5 V
Output current, charger 600 mA
Sound pressure level
(EN 60704-2-1)
50 dB(A)
Weight 0,6 kg
Battery type Li-Ion
13EN
To Next Page
Loading...
Need help?
General
Weight and Dimensions
