39
Figure 7.7
7.14 Adjusting the Seat Height
7.14.1 The seat post rests on a seat height adjustment pin that runs through the
center of the frame post. There are three holes in the frame post that allow
you to adjust the seat height to 17.5"(44.5 cm), 18.5"(47 cm) or 19.5"(49.5 cm).
The adjustment pin is nestled between the two batteries and is hidden
behind the main wiring connected from the central relay box (controller) to
the front of the scooter. (See Figure 7.9).
7.14.2 To adjust the seat height, remove the seat by following the previous
instructions. Next, remove both bolts from the two frame posts. (You might
want to disconnect the batteries to allow more room to work). Place the pin
in the desired hole and move the wiring back into its place. Then install the
seat following the previous instruction. Mission accomplished!
7.14.3 Slide the upper frame post up or down to the desired position. Place the seat
height adjustment bolt in the lowest hole (of the upper frame post) and
tighten its hex nut with two 17 mm wrenches. Use one 17 mm wrench to
insert the threaded stability bolt in the second lowest hole (of the upper
frame post which is also threaded.)
7.14.4 Now you can replace the rear casing and install the seat following the
previous instructions.
CAUTION
● The stability knob should not be used to adjust the seat height
To Next Page
Loading...
Need help?
General
