- 12 -
ATTACHMENTS
CAUTION
DO NOT attach or remove handle or wands while vacuum cleaner is ON. This could
cause sparking and damage the electrical contacts or electronic controls.
ATTACHMENT STORAGE
This canister is equipped with an on-board storage area for attachments.
TO REINSTALL:
1. With the floor brush on the wand, insert
the floor brush into place.
POP-N-GO FLOOR BRUSH
1. Press the release button to open the tool
storage cover. The neck of the floor brush
will pop up at an angle that makes it easy
to attach the wand.
2. Push the wand collar over the floor brush
neck. Tilt wand upward and lift out.
2. Tilt the wand and floor brush downward.
3. Pull the wand
away from the
floor brush. The
floor brush will
disconnect from
the wand.
4. Close the
tool storage
cover securely.
NOTE: If there is difficulty attaching brush
to wand in the manner described above,
simply remove the brush from storage
compartment and insert it into the wand
collar.
NOTE: If there is difficulty detaching the
wand from brush in the manner described
above, simply press the Tool Release button
to disconnect brush from wand.
To Next Page
Loading...
Need help?
General
