5
INSTALLATION INSTRUCTIONS
Installer: Leave Use and Care Guide with the homeowner.
Homeowner: Keep Use and Care Guide for future reference and
for local electrical inspector’s use, if required.
Unpacking
IMPORTANT: Begin in the room where the compactor will be
located.
1. Remove compactor from shipping carton. Remove all
protective packaging materials such as tape and shipping
pads. Use a mild detergent and warm water to remove waxy
residue caused by protective shipping material. Dry
thoroughly with a soft cloth. For more information, see
“Cleaning.”
2. Check to be sure the power cord is attached to the cord clip
on the rear of the compactor.
3. Place the 2 corner posts from the carton on the floor near the
compactor. Press the foot pedal to open the compactor
drawer and remove any shipping materials or other items
from the drawer. Do not remove the compactor bag. Grasp
sides of drawer and lift drawer out of compactor. Place the
drawer on the 2 corner posts.
4. Place the other 2 corner posts on the floor to the side of the
compactor. Grasp the sides of the compactor cabinet and put
compactor on its side on top of the corner posts. Remove the
shipping base from the bottom of the compactor.
Location Requirements
Product dimensions
A. Cord clip
WARNING
Excessive Weight Hazard
Use two or more people to move and install
compactor.
Failure to do so can result in back or other injury.
A
A. Leveling legs
B. Shipping base
A
34¹⁄₈"
(86.7 cm)
24"
(61 cm)
15"
(38.1 cm)
To Next Page
Loading...
Need help?
General
