Contro Pad Features
Note: The appearance of your oven controU may differ sHghtUyfrom the one HUustratedbebw, However, aH functions
are the same, Also, push buttons or pads may be shaped differently than those appearing in this Use and
Care Guide,
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN. For satisfactory use of your oven, become
familiar with the various functions of the oven as described bebw,
OVEN CLOCK SET COOK TiME
INTER(OR PAD Used to PAD Used to
LIGHT PAD set the time
Used to turn of day.
oven interior light
ON
Used to set or cancel
the minute timer. The
minute timer does not"_..
start or stop cooking.
Also, TIMER SET/OFF
UP and DOWN ARROWS PADS Used ADD 1 MINUTE PAD Used to add 1 BAKE PAD--
along with the function pads to select minute to the Timer Count-down. This Used to select
enter the length oven temperature, cook time, start time feature works with the Kitchen Timer the bake
of the baking (when programming an automatic start only and does not affect any cook time function.
time.
time), time of day, clean time and or start time functions. (some models). /
\
\ minute timer. FEATURE
/
.......J INDICATOR
.............if" UGHTS--
\_ These light to
show which
feature is in
use.
Pad is used to set the @ O @ O BROIL PAD--
SELECTContinuousBake_SELF= / _ _ _ Usedtoselect
Feature. @ 0vel_ the variable broil
® Preheat function.
CLEAN PAD Used to / _ Doer[eeked _-- WARM & HOLD
select the Self- _ k PAD-- Used to
Cleaning cycle. A 2, 3 _ __ . set the Warm &
or4hourSelf-Clean I Holdfeature.
time may be selected /
(some models). / 7-- -----
/
OVEN,
PRE
HEAT & DOOR LOCK UGHTS* The "Oven" might STOP CLEAR PAD-- Used to clear
will glow each time the oven unit turns on to maintain the set any function previously entered
DELAY START PAD Used to set the
oven temperature. The "Preheat" Hght will glow when the oven except the time of day and minute
desired start time for baking. May be
is first set to operate, or if the desired temperature is reset timer. Press STOP CLEAR to stop
used with COOK TIME to program a higher than the actual oven temperature. The "Door Locked" cooking. Also the STOP CLEAR
delayed bake cycle or a delayed clean might will flash until the door locks when the self-clean cycle is in pad is used to activate oven lockout
cycle, use. It glows constantly after the door locks (some models), setting. (some models).
*Note: The OVEN indicator light on the electronic display wiii turn ON and OFF when using the Bake feature and
during preheat, This is normal and indicates that the oven is cycling to maintain the selected baking temperature,
When preheat indicator light turns OFF, your oven is ready,
For a silent contro_ pane_:
When choosing a function, a beep will be heard each time a pad is pressed, If desired, the control can be programmed
for silent operation,
1, To tell if your oven is set for normal or silent operation press and hold _I_ for 7 seconds, "- - " or "SP" appears in
the display,
2, Within 5 seconds, press the A or v pad to switch between normal sound operation and silent operation mode,
The display will show either "- - " or "SP",
3, Wait 5 seconds to return to normal operating mode,
If "SP" appears, the control will operate with normal sounds and beeps, If "- - " appears, the control is in the silent
operation mode,
Temperature Conversion (Fahrenheit / Celsius)
The electronic oven control is set to operate in °F (Fahrenheit) when shipped from the factory, The oven can be
programmed for any temperature from 170°F to 550°F (77°C to 288°C),
To change the temperature to °C (Celsius) or from °C to °F (control should not be in a Bake or Ctean mode):
1, Press and hold ,for 7 seconds until °F or °C appears in the display,
2, Press the A or v pad to change °F to °C or °C to °F,
8, Wait 5 seconds to accept the changes or press i to reject the changes,
To Next Page
Loading...
Need help?
General