ThisOwner'sGuideprovidesspecificoperatinginstructions
foryourmodelUsetherefrigeratoronlyasinstructedin
thisOwner'sGuide,Beforestartingtherefrigerator,
followtheseimportantfirststeps.
LOCATION
. Choose a place that is near a grounded electrical
outlet Do Not use an extension cord or an adapter
plug,
• ff possible, place the refrigerator out of direct sunlight
and away from the range, dishwasher or other heat
sources
• The refrigerator must be installed on a floor that is
level and strong endugh to support a fully loaded
refrigerator
- Consider water supply availability for models equipped
with an automatic ice maker.
INSTALLATION
- Do not install the refrigerator where lemperature will
drop below 60°F (15°C) or rise above 110°F (43°C),
The compressor will not be able to maintain proper
temperatures
• In a recessed installation, allow an extra 1/2 inch
(10-15 ram) on each side, for ease of installation
- To permit proper door swing, if the hinge side of the unit
will be placed against a walt, allow a 1- 3/4 inch
(44 ram) space between the wall and the refrigerator
DOOR OPENING
For best use of drawers and freezer basket, refrigerator
should be in a position where both refrigerator and freezer
doors can be opened about 135 _
LEVELING
• Refrigerator must be leveled with all bottom corners
resting firmly on a solid floor Adjust front rollers to
level cabinet both front-to-rear and side-to-side Keep
cabinet as low as possible for stability Never adjust
cabinet rollers so front is lower than rear.
° To adjust front rollers: Open refrigerator and Ireezer
doors Remove toe grille by pulling it straight out
Adjust roliers by turning each roller adjusting bolt with
an adjustable wrench, a socket wrench, or a nutdriver
until the refrigerator is level and stable Rear rollers
are not adjustable.
. Check both doors to ensure the seals touch the
cabinet evenly on all four corners
• If freezer door is higher than refrigerator door,
raise right corner and/or lower left corner until doors
align across top of cabinet,
• If refrigerator door is higher than freezer door,
raise left corner and/or lower right corner untiI doors
at}gn across top of cabinet°
Ro!_er Adiu_ng Bolt
Adiust_ng Front Rot_ets
R_pla=n9 Tc_ G_3b
- To replace toe grille: Line up tabs with holes, and
push grille straight on.
CLEANING
. Wash the inside, all removable parts, and theoutside
with mild detergent and warm water Wipe dry, Do Not
use harsh cleaners on these surfaces.
• Do not use razor blades or other sharp instruments
that can scratch appliance surface, when removing
adhe siva labels. Any glue teft from tape or energy tabor
can be removed with a mixture of warm water and mild
detergent, or touch residue with sticky side of tape
already removed
• Do not remove the Serial Plate.
To Next Page
Loading...
Need help?
General
