INSTALLATION - INSERT HEATERS ONLY
WARNING: This appliance and flue MUST be installed in a full masonry fireplace, and must
be installed by a qualified wood heater installer according to the latest version of AS2918.
6
Top view
Dimensions
Side view
Dimensions
Dimensions
Evolution 4
Evolution 6
All dimensions are in millimetres
8051032675520705
755932625520605
705870575470545
firebox
width
firebox
depth
firebox
height
facia
width
facia
height
NMLKJ
Evolution 8
FIREPLACE CONSTRUCTION
This wood heater be installed in a fullmust
masonry fireplace, which has been carefully
inspected for cracks or deterioration. The chimney
should be cleaned prior to installation.
You install a flue the entire length of themust
chimney. This will help your heater perform to its
full capabilities. It is also easier to clean.
CLEARANCES TO COMBUSTIBLES
The table and diagram below shows the minimum
clearances (in millimetres) to combustible
materials.
Clearance ‘A’ is from the top of the hearth to the
underside of the combustible mantlepiece.
Clearance ‘B’ is between the combustible
surround columns.
A
B
HEARTH CONSTRUCTION
Do not build the hearth over the front of the heater
as this will prevent access to the fan through the
front bottom air inlet cover.
Please refer to the requirements and diagram
below:
Evolution 4 insert heater: The hearth shall consist
of no less than 45 mm thick compressed fibre
cement sheet, with thermal conductivity not
greater than 0.33 W/m°K.
Evolution 6 or Evolution 8 insert heater: The
hearth shall consist of no less than 30 mm thick
compressed fibre cement sheet with a 15 mm air
gap underneath. The cement sheet shall have a
thermal conductivity not greater than 0.33
W/m°K. The air gap must provide a minimum of
3,750 mm² on each side (eg. two slots of 125 mm
x 15 mm ventilation on either side).
D
C
Evolution 4 insert
Evolution 6 insert
11301445
10301465
9201420
BA
Evolution 8 insert
All dimensions are in millimetres
Evolution 4 insert
Evolution 6 insert
1033605
930605
900500
DC
Evolution 8 insert
All dimensions are in millimetres
To Next Page
Loading...
Need help?
General
