Kenwood 104AR User Manual

In case of difficulty
Operation to reset
104AR {En]
Unplug the AC power cord from the wall outlet, then plug it
back in white holding down the MEMORY key.
The microcomputer may fail into malfunction {impossibility to
operate, erroneous display, etc.) when the power cord is un-
plugged while power is ON or due to an external factor. In this
case, execute the following procedure to reset the microcom-
puter and return it to normal condition,
Remote control unit
“Symptom:
©
Remote control operation is not possible.
Amplifier
Sound is not output.
e@
Please
note
that
resetting
the
microcomputer
clears
the
contents
stored
in
it
returns
it
to the
condition
when
it
left
the
factory
e@ Batteries are exhausted
@ The remote control unit is too far away from
the main system, controlling angie is too
large, or there is an obstacle in between
@ The audio cords and system control cords
are not connected properly
@ The source component to be operated does
not contain the tapeis} or CD.
e An attempt iS made to play a tape which Is
being recorded in the cassette deck
@ The speaker cords are disconnected.
@ Tre VOLUME ts set to the minimum posi-
1los
e@ The SPEAKERS switches are set to OFF.
e@ The TAPE @ key is set to ON.
a 5
The STANDBY indicator blinks and sound
is not output.
@ Speaker cords are short-circuited.
Sound is not output from one of the
speakers.
A hum noise is generated when the
PHONO input selector is selected.
Radio stations cannot be received.
Interference.
A station which was preset cannot be re-
ceived by pressing the corresponding nu-
meric key.
es
@ fhe speaker cord :s disconnected.
e The BALANCE control is set to an extreme
Position
@ Tne audio cord from the turntable is not in-
serted securely into the PHONO jacks.
e@ The turntable 1s not grounded
@ No antenna is connected.
e The broadcast band is not set properly...
e@ The frequency of the desired station is not
tuned
@ Noise due to ignition noise of an automobile.
e@ Noise due to an influence from an electric
appliance
@ Noise due to a nearby TV set.
@ The preset station belongs to a frequency
that cannot be received
@ The preset memory was cleared because
the power cord had been unplugged for a
long period of time. :
® Replace with new batteries >
@ Operate the remote control unit within
the controllable range.
@ Connect properly referring to “System
connections”.
ponent to be played.
e Wart until the recording is completed.
® Connect them properly referring to “Sys-
tem connections”.
e Adjust the volume to a proper level
@ Set the SPEAKERS switchies} to ON.
@ Set the TAPE 2 key to OFF.
® Turn the power off, eliminate the short-
circuiting, then turn on the power again
~ E..
e@ Connect it property referring to “System
connections ”.
@ Adjust the Left/Right balance.
@ Insert the audio coed plugs securely into
the PHONO jacks. ;
® Connect the grounding wire to the GND
terminal on the rear panel.
@ Connect an antenna.
e@ Set the broadcast band properly
@ Tune the frequency of the desired station.
(ia.
@ Instail the outdoor antenna away from the
road. ;
@ Turn off the power to the appliance
e Install the system farther away from the
TV set.
e Preset a station with a receivable fre-
quency.
@ Preset the station again
Do
not
use
contact
cleaners
because
it
could
cause
a
malfunction.
Be
specially
careful
against
contact
cleaners
containing
oil,
for
they
may
deform
the
plastic
components.

Kenwood 104AR Specifications

General

Brand	Kenwood
Model	104AR
Category	Stereo Receiver
Language	English