troubleshooting
solution
●
●
1
2
3
4
5
6
1
2
3
4
5
●
●
6
problem
The whisk or K-beater knocks against the bottom of the bowl or isn’t
reaching the ingredients in the bottom of the bowl.
Adjust the height. Here’s how:
Unplug.
Raise the mixer head and insert the whisk or beater.
Hold it, then loosen the nut
Lower the mixer head.
Adjust the height by turning the shaft. Ideally the whisk/K-beater should
be
almost touching the bottom of the bowl
Raise the head, hold the whisk/K-beater and tighten the nut.
to fit and use your round/D-shaped
splashguard (if supplied)
Raise the mixer head until it locks.
Fit the bowl onto the base.
Push the splashguard on until fully located
. The hinged section
should be positioned as shown round
and D-shaped
Insert required tool.
Lower the mixer head ensuring the splashguard follows the shape of
the bowl.
During mixing, ingredients can be added directly to the bowl via the
hinged section of the splashguard.
You do not need to remove the splashguard to change tools.
Remove the splashguard by raising the mixer head and sliding it down.
3
KENWOOD CHEF KM300, 400, 410 / MAJOR KM600, 800, 810
To Next Page
Loading...
Need help?
General