6
before plugging in
l
M
ake sure your electricity supply is the same as the one
shown on the underside of your appliance.
Important – UK only
l
T
he wires in the cord are coloured as follows:
B
lue = Neutral, Brown = Live.
l
The appliance must be protected by a 3A approved
(BS1362) fuse.
Note:
l
For non-rewireable plugs the fuse cover MUST be
refitted when replacing the fuse. If the fuse cover is lost
then the plug must not be used until a replacement can
be obtained. The correct fuse cover is identified by
colour and a replacement may be obtained from your
Kenwood Authorised Repairer (see Service).
l
If a non-rewireable plug is cut off it must be
DESTROYED IMMEDIATELY. An electric shock hazard
may arise if an unwanted non-rewireable plug is
inadvertently inserted into a 13A socket outlet.
l
This appliance conforms to EC directive 2004/108/EC
on Electromagnetic Compatibility and EC regulation no.
1935/2004 of 27/10/2004 on materials intended for
contact with food.
before using for the first time
1 Remove the plastic blade covers from the knife blade.
Take care the blades are very sharp. These
covers should be discarded as they are to protect the
blade during manufacture and transit only.
2 Wash the parts see ‘care & cleaning’
key
processor
햲 pusher
햳 feed tube
햴 lid
햵 safety interlock
햶 bowl
햷 food processor drive
햸 speed/pulse control
햹 power unit
햺 liquidiser outlet/interlock
햻 cord storage (at back)
햽 liquidiser outlet cover
liquidiser
햾 goblet
햿 lid
헀 filler cap
attachments
헁
knife blade
헂 slicing plate
헃 shredding plate
헄
plate carrier
헅 whisk
헆 maxi-blend canopy
citrus press (if supplied)
to use your food processor
1 Fit the bowl onto the processor base - handle towards
the back - lower and turn clockwise until it locks firmly
into place .
2 Add an attachment over the food processor drive.
l
Always fit the bowl and attachment onto the processor
before adding ingredients.
3 Fit the lid onto the bowl - feed tube towards the back of
the appliance . Turn clockwise until the arrow on the
lid aligns with the line on the power unit .
l
Do not use the lid to operate the processor,
always use the on/off control.
4 Plug in, switch on and select a speed. (Refer to the
recommended speed chart).
l
The processor won’t work if the bowl and lid
are fitted incorrectly.
l
Use the pulse (P) for short bursts. The pulse will operate
for as long as the control is held in position.
5 Reverse the above procedure to remove the lid,
attachments and bowl.
l
Always switch off and unplug before removing
the lid.
important
l
Your processor is not suitable for crushing or grinding
coffee beans, or converting granulated sugar to caster
sugar.
l
When adding almond essence or flavouring to mixtures
avoid contact with the plastic as this may result in
permanent marking.
to use your liquidiser
1 Put your ingredients into the goblet.
2 Fit the filler cap to the lid.
3 Turn the lid in a clockwise direction to lock onto the
goblet.
4 Lift off the liquidiser outlet cover 햽.
5 Place the liquidiser onto the liquidiser outlet and turn to
lock.
important
l
The liquidiser attachment will work only with
the processor bowl and lid in position.
To Next Page
Loading...
Need help?
General
