centrifugal juicer
Use the centrifugal juice for making juice from firm fruit and
vegetables.
pusher
lid
strainer
inner bowl
to use the centrifugal juicer
1 Fit the drive shaft and bowl onto the power unit.
2 Lock the strainer into the inner bowl .
3 Fit the inner bowl into the processor bowl .
4 Place the attachment lid onto the bowl, turn until it locks and
the feed tube sits over the handle .
5 Cut the food into small pieces to fit the feed tube.
6 Switch on and push down evenly with the pusher - never
put your fingers in the feed tube. Process fully before
adding more.
7 After adding the last piece, let the machine run for a further
20 seconds to extract all the juice from the strainer.
important
●
If the processor vibrates, switch off and empty the strainer
(The processor vibrates if the pulp becomes unevenly
distributed).
●
Process small amounts at a time (450g maximum) and
empty the strainer and inner bowl regularly.
●
Before processing remove stones and pips (eg pepper,
melon, plum) and tough skins (eg melon, pineapple). You
don’t need to peel or core apples and pears.
hints
●
Use firm, fresh fruit and vegetables.
●
Citrus juice will be bitter and frothy because its peel and pith
get processed too. Use the citrus juicer instead.
KENSTORE™ attachments
carousel
Your food processor is supplied with an attachment storage
carousel that fits inside the bowl.
to use the storage carousel
1 Fit the knife blade to the bowl.
2 Then fit the whisk, discs and canopy into the carousel .
3 Fit the carousel over the knife blade and place the processor
lid on top .
care & cleaning
●
Always switch off and unplug before cleaning.
●
Handle the blades and cutting discs with care - they are
extremely sharp.
●
Some foods may discolour the plastic. This is perfectly
normal and won’t harm the plastic or affect the flavour of
your food. Rub with a cloth dipped in vegetable oil to
remove the discolouration.
power unit
●
Wipe with a damp cloth, then dry. Ensure that the interlock
area is clear of food debris.
●
Store excess cord in the storage area at the back of the
machine .
liquidiser and mini chopper/mill
1 Empty the jug/jar before unscrewing it from the blade unit.
2 Wash the jug/jar by hand.
3 Remove and wash the seals.
4 Don’t touch the sharp blades – brush them clean using hot
soapy water, then rinse thoroughly under the tap. Don’t
immerse the blade unit in water.
5 Leave to dry upside down.
twin beater geared whisk
●
Detach the beaters from the drive head by gently pulling
them free. Wash in warm soapy water.
●
Wipe the drive head with a damp cloth, then dry.
Do not immerse the drive head in water.
all other parts
●
Wash by hand, then dry.
●
Alternatively they can be washed on the top rack of your
dishwasher. A short low temperature programme is
recommended.
service and customer care
●
If the cord is damaged it must, for safety reasons, be
replaced by KENWOOD or an authorised KENWOOD
repairer.
If you need help with:
●
using your appliance or
●
servicing or repairs
Contact the shop where you bought your appliance.
●
Designed and engineered by Kenwood in the UK.
●
Made in China.
7
To Next Page
Loading...
Need help?
General
Weight and Dimensions
