EW-BA-defsi-0620
21
Display panel
5 Installation
Please note that your KERN balance is a precision weighing instrument. Even if the
instrument is made for robust and continuous use, please handle it carefully and do
avoid unnecessary use.
The balance requires a warm-up time. The optimum weighing results are achieved
when starting to used the balance only 5 minutes after turning it on.
6 Power supply
Plug balance into a socket 230 V / 50 Hz. Do not connect it when there should be
another mains voltage.
Socket must be grounded as per VDE prescription. Inspection by authorised special
electrical shop only.
Plug the adapter cable on the back of the balance.
Only then:
Plug the given mains adapter (230 V AC / 9 V DC / 400 mA) in the socket.
The balance is now in the Standby mode, see "Power Display *"
Press now the ON/OFF key
The balance performs now a self-check.
After approx. 5 - 8 seconds the balance is ready to operate.
To Next Page
Loading...
Need help?
General
