13
Don’t forget! Set your Operating Mode to Ballistics on
the Options Menu to use Ballistics features!
For ease of access, the ballistics Targeting Screen also
contains the Ballistics Menu. Simply scroll down from the
Targeting Screen to access these settings and submenus:
» Target
» Wind
» Gun
» Environment
» Range Card
(Elite Model only)
» Ballistics (Limited on Sportsman model, full on Elite model)
» Manage Guns
Note! The back of this guide contains a full Glossary of the terms used.
Please read these denitions!
CREATE OR EDIT A GUN PROFILE:
» Scroll to and select Manage Guns. Either select an
existing gun to edit or select New Gun.
» Scroll up and select Gun to rename the gun. Use the
scroll/adjust buttons to enter a new name, then exit
the naming menu.
» Set the remaining values in the Gun sub menu to
match your gun, bullet and scope combination.
» Exit to the Manage Guns menu and ensure the new
gun is set to On.
CREATING GUN & BULLET PROFILES
EDIT TARGET:
» Scroll to and select Tgt.
» Set range, angle, target speed, and wind values
to match your target.
EDIT TARGET OR CREATE ADDITIONAL TARGETS:
(Elite model only)
» Scroll to and select Tgt.
» Set range, angle, target speed, and wind values
to match your target.
The elite model allows up to ve targets (A TO E).
» Make sure Target is set to Active.
» To enable more than one target, or edit other
active targets, scroll up to the header named
Target and use the left/right buttons to scroll
between targets (A through E). Set a target to
Active to enable it, then edit its values.
» When only one target is active, its range can also
be modied directly from the main Targeting
Screen by highlighting Tgt and scrolling left or
right.
» If more than one target is set to Active,
highlighting Tgt in the main Targeting screen
and scrolling left or right will scroll between
active targets.
CREATING TARGETS
Shop for Quality products online at:
1.800.561.8187
www.SCOUTBASECAMP.ca
To Next Page
Loading...
Need help?
General
