19
EN
-
dard system are listed in the cables list table.
Before installing the product, perform the following checks and in-
spections:
check that the gate, the door or the barrier is suitable for automation;
the weight and size of the gate or door and the balance of the barrier
-
tion system in which the product is installed;
stops;
high acidity or salinity or nearby heat sources might cause the pro-
duct to malfunction;
in case of extreme weather conditions (e.g. snow, ice, wide tempe-
rature variations or high temperatures), friction may increase, cau-
sing a corresponding rise in the force needed to operate the system;
the starting torque may therefore exceed that required in normal
conditions;
check that when operated by hand the gate, the door or the barrier
moves smoothly without any areas of greater friction or derailment
risk;
check that the gate, door or the barrier is well balanced and will the-
refore remain stationery when released in any position;
check that the electricity supply line to which the product is to be
connected is suitably earthed and protected by an overload and dif-
ferential safety breaker device;
he system power supply line must include a circuit breaker device
with a contact gap allowing complete disconnection in the condi-
ensure that all the material used for installation complies with the
relevant regulatory standards.
-
- Power supply with protection against short-circuits inside the con-
trol unit, on motors and on the connected accessories.
- Obstacle detection.
- Automatic learning of working times.
- Safety device deactivation by means of dip switches: there is no
need to bridge the terminals of safety devices which are not instal-
led - the function is simply disabled by means of a dip switch.
* Se il cavo di alimentazione supera i 20 m di lunghezza occorre utilizzare un cavo con sezione maggiore (3x2,5 mm
2
) ed è necessario
installare una messa a terra di sicurezza in prossimità dell’automazione
Power supply (L-N)
Max motor load 150 W
Output for Vac accessories power/device test power Vdc
24 Vac without regulation 200 mA / 24 Vdc without regu-
lation 250 mA
Courtesy light output 24 Vdc 25 W
Flashing light output 24 Vdc 25 W
Pause time
Operating temperature -20 °C + 55 °C
230 Vac power supply line fuses
1.6 A slow-acting
Max. number of transmitters storage FIX CODE 150 transmitters
150 transmitters
Connection
Control unit power supply line 1 x cable 3 x 1,5 mm
2
20 m *
Flashing light, courtesy light
Antenna
3 x 0,5 mm
2
**
20 m
20 m (advised < 5 m)
Electric lock 1 x cable 2 x 1 mm
2
10 m
1 x cable 2 x 0,5 mm
2
20 m
1 x cable 4 x 0,5 mm
2
20 m
Sensitive edge 1 x cable 2 x 0,5 mm
2
20 m
Key-switch 1 x cable 4 x 0,5 mm
2
** 20 m
To Next Page
Loading...
Need help?
General
