4
EN
2 - PRODUCT OVERVIEW
2.1 - Description of the product
The STAR gear motors are destined to be installed in systems for
the automation of gates with hinged doors.
The STAR gear motors have been designed and constructed to be
tted onto hinged doors within the weight limits indicated in the tech-
nical specications table.
The use of gear motors for applications which dier from those indi-
cated above is prohibited.
2.2 - Technical characteristics
3 - PRELIMINARY CHECKS
Before installing this product, verify and check the following steps:
- Check that the gate or door are suitable for automation
- The weight and size of the gate or door must be within the maxi-
mum permissible operating limits specied in Fig. 2
- Check the presence and strength of the security mechanical stops
of the gate or door
- Check that the mounting area of the product is not subject to ood-
ing
- Conditions of high acidity or salinity or proximity to heat sources
could cause malfunction of the product
- Extreme weather conditions (for example the presence of snow,
ice, high temperature range, high temperatures) may increase the
friction and therefore the force required for the handling and initial
starting point may be higher than under normal conditions.
- Check that the manual operation of gate or door is smooth and
friction-free and there is no risk of derailment of the same
- Check that the gate or door are in equilibrium and stationary if left
in any position
- Check that the power line to supply the product is equipped with
proper grounding safety and protected by a magnetothermal and
dierential security device
- Provide the power system with a disconnecting device with a gap
of contacts enabling full disconnection under the conditions dictated
by the overvoltage category III.
- Ensure that all materials used for the installation comply with cur-
rent regulations
TECHNICAL DATA
MODELS STAR2024 STAR3024
TECHNICAL SPECIFICATIONS
Speed cm/s 2,5 2,5
Thrust Force N 1400 1400
Working cycle % 80 80
Opening time at 90° sec adjustable adjustable
Control unit CT20224 CT20224
Power supply Vac (Vdc) (24) (24)
Absorption A 3,5 3,5
Engine power W 85 85
Degree of protection IP 54 54
Dimensions (L - P - H) mm 646 - 115 - 177 796 - 115 - 177
Weight Kg 3 3,2
Operating temperature °C -20°+55 -20°+55
Leaves maximum weight Kg 400 400
To Next Page
Loading...
Need help?
General
