GENERAL GI -17
6. Plastic nuts
EAK
E005G
Depending on their location.
7. Sealant should be applied to gaskets.
8. Oil should be applied to the moving components of
parts.
9. Specified oil or grease should be applied to the pre-
scribed locations (oil seals, etc.) before assembly.
EAKE005H
ADJUSTMENT
Use gauges and testers to adjust correctly the parts to
standard values correctly.
ELECTRICAL SYSTEM
1. Be sure to disconnect the battery cable from the neg-
ative (-) terminal of the battery.
2. Never pull on the wires when disconnecting connec-
tors.
3. Locking connectors will click when the connector is
secure.
4. Handle sensors and relays carefully. Be careful not to
drop them against other parts.
EAKE005I
RUBBER PARTS AND TUBE S
Always prevent gasoline or from touching rubber parts or
tubing.
EAKE005J
To Next Page
Loading...
