Mounted
in
the Bow
INSTALLATION
Possible locations
for KM
Coaxial
Speaker Mounting
Stern
Mounted
Mounting:
Make sure the
stainless steel mounting screws and U-type speed
clips
will
not puncture the
fuel cell,
wiring, or interfere with any
mechanical parts on the underside of the mounting surface. Pre-drill
the mounting screw
holes
using a
7
/64
" (2.5mm) bit, and attach the
KM
coaxial
speakers to the boat
by fastening the
supplied stainless steel
coarse-threaded screws to the boat's structure.
If
applicable,
use the
enclosed stainless steel
U-type speed
clips.
If
the
supplied
hardware
is
not
applicable to your
installation, some other means of securely
attaching the speakers to the boat must be used.
Wiring:
Carefully place
the speaker wire
in
a
location
that
is
clear
of standing water and moving
components of the boat. For reference, the
Blue wire
is
Positive and the Grey wire
is
Negative. The
locking terminal
cover with water resistant gasket
is
removable
for wiring installation;
it
helps
prevent
terminal
corrosion and
electrical
shorting. Connect the
gold-plated male quick-disconnect
on
the end of
the 18 inch (46cm) speaker wire
leads
coming out of the sealed
speaker basket to the wires from your
amplifier
or source unit.
Place
the connected wires into the
locking terminal,
making sure the divider
separates the
blue
and
silver
wire quick disconnects, and snap the
locking terminal
cover into place.
Connect the other end of the wire to your
amplifier
in
accordance with its owner's manual.
Mount the
locking terminal
cover
in
a
location
free and
clear
of standing water by
utilizing
the
supplied
zip ties
through the integrated loops
in
the
locking terminal cover.
Mount the speaker and
grille
right side-up to take
advantage of the
coaxial
system's integrated
moisture draining system.
Locking Terminal
Cover
Wire Divider
Loops for mounting with Zip Ties
3
To Next Page
Loading...
Need help?
General
