CAUTION: THIS UNIT IS SEALED (INCLUDING THE BATTERY).
THE COVER IS NOT REMOVABLE!
This alarm has lithium batteries permanently sealed inside the alarm, no
battery installation or maintenance is necessary.
The alarm is shipped turned off and is activated the first time the
mounting bracket is attached. To activate the alarm: for wall mounting,
install the mounting bracket using the instructions below and slide the
alarm until it snaps into place. Alternately for table top applications,
simply slide the bracket on to the unit until snaps in place.
Note: Numerous or prolonged period of alarming is not typical and will
consume the battery capacity, shortening the life of the product.
Extensive cycling between high and low temperatures will significantly
reduce battery life. Long term exposure to high temperatures will
degrade the battery over time. Kidde recommends locating this alarm in
a controlled temperature environment (68-86ºF) for optimum life.
After installing your alarm, test it by using the Test/Reset button and
check that the green “Power” LED blinks on.
4. Installation Instructions
2537-7201-01_V1.indd 122537-7201-01_V1.indd 12 2012.11.2 9:37:08 AM2012.11.2 9:37:08 AM
To Next Page
Loading...
Need help?
General
