EasyManua.ls Logo

Kidde KN-COPP-3-RC User Manual

Kidde KN-COPP-3-RC
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background image
7. Maintenance
NOTE: This unit is sealed. The cover is not removable.
Due to the loudness of the alarm, we suggest that you place your
fingers over the sounder opening while testing your alarm.
Caution: Continuous exposure to the high sound level of this
alarm over an extended period of time may cause hearing loss.
Testing
To test the alarm, press the Test/Reset button. If the unit is operating
properly, you will hear 4 quick beeps – followed by 5 seconds of silence
followed by 4 quick beeps. The display will show three “eights” and
then show a number – usually around 200). Within several seconds the
unit will return to monitor for CO.
Note: You do not need to press the Test button to take a CO
reading.
Battery Replacement
NOTE: This CO alarm is not battery operated. However, these alarms
are equipped with 8 volt Lithium Ion battery backup – the 8 volt battery
is to supply short term back-up during a power outage.
WARNING: Replace the battery pack only with a Kidde
rechargeable battery pack. Replacement battery packs can be
purchased from Kidde customer service.
Upon initial power up or after the alarm has operated on battery backup
and depending on the charge state of the battery, it could take up to 20
hours to FULLY charge the battery.
During the first 10-hour initial charge period or, until the battery has
charged, “Lb” will be displayed along with the CO level (usually “0”)
and without an audible “beep”. When the initial charge is complete, the
“Lb” will disappear. If however, after 10 hours the battery is not
charging properly, “Lb” may continue to flash AND there will be an
audible “beep” once every 15 seconds indicating the battery is not
charging. If this occurs, make sure the connection between the battery
and the alarm is correctly oriented and fully seated. If not, disconnect
the battery and reconnect insuring the alignment ribs match the slot in
the battery. If it is properly connected and fully seated and “Lb” is still
displayed along with an audible “beep”, contact customer service.
Question and Answer IconNeed help?

Do you have a question about the Kidde KN-COPP-3-RC and is the answer not in the manual?

Kidde KN-COPP-3-RC Specifications

General IconGeneral
TypePlug-in with battery backup
Sensor TypeElectrochemical
Test ButtonYes
Low Battery IndicatorYes
Warranty10-year limited warranty
Alarm Sound Level85 dB at 10 feet
End of Life SignalYes
Batteries2 AA (included)
Operating Temperature40°F to 100°F (4°C to 38°C)
Operating Humidity10% to 95% relative humidity
Alarm Level70 ppm

Summary

Responding to Alarm Activation

Carbon Monoxide Alarm Procedure

Step-by-step guide on what to do if the CO alarm sounds, including evacuation and contacting services.

Introduction and Safety Information

Welcome to Your Kidde CO Alarm

Introduces the Kidde Carbon Monoxide alarm and its role in home safety.

Important Warning Statements

Critical safety notices and product limitations for user protection.

User Guide Contents Overview

Lists the main sections of the user manual for easy navigation.

Understanding Carbon Monoxide Hazards

CO Properties, Symptoms, and Levels

Explains CO nature, health effects, symptoms, and concentration levels.

CO Sources and Production Conditions

Details common household sources and environmental factors that can produce CO.

CO Alarm Capabilities and Limitations

Clarifies what the alarm detects and its operational boundaries.

Product Features and Installation Guide

Product Features and Specifications

Identifies key components and lists technical specifications of the alarm unit.

Installation Locations: Recommendations and Avoidances

Guides on recommended placement and areas to avoid for optimal alarm function.

Installation Instructions and Mounting Options

Step-by-step guide for battery installation and various mounting options.

Operation and Alarm Characteristics

Alarm Characteristics: Indicators and Sounds

Explains the different alarm sounds, visual indicators, and unit status signals.

Operating Characteristics: Display and Power Modes

Details digital display readings, AC/DC operation, and battery backup status.

Peak Level Memory Function

How to view and reset the highest CO concentration recorded by the alarm.

Maintenance and Warranty Information

Routine Testing and Maintenance Tips

Instructions for regular testing, cleaning, and basic upkeep of the alarm.

Battery Replacement and Handling Precautions

Guidance on replacing the battery pack and safe handling of lithium-ion batteries.

Seven Year Limited Warranty

Outlines the terms, conditions, and coverage period of the manufacturer's warranty.