High, mid and low speeds can be se-
lected by the range shift lever.
Follow the instruction below if a prob-
lem occurs during shifting this lever:
1. Put the range shift lever into the
neutral position.
2. Depress the pedal slightly to pre-
vent the gears in the transmission
from rotating.
3. Shift the range shift lever into the
desired position with the brake
(1) Range Shift Lever
( ) High Speed ( ) Mid Speed
( ) Low Speed (N) Neutral
6 speeds can be selected by the
range shift lever. Only shift the range
shift lever after the tractor is com-
pletely stopped by depressing the
clutch pedal.
If the lever close to move freely or
makes abnormal noise, put the lever
into the neutral position, engage and
disengage the clutch, and then try to
shift the lever.
RANGE GEAR SHIFT LEVER
[MANUAL] [HST]
TE1O491B TE1O492C
Make sure to shift the range
gear shift lever with the clutch
pedal depressed and the trac-
tor stationary (Manual Type).
Never put the range shift lever
into the high speed position
during driving backward as it
is dangerous to drive at a high
speed.
The tractor is not braked by
depressing the brake pedal
without depressing the clutch
pedal at a low speed as rota-
tional force of the axle has a
major effect at a low speed.
Th e r e fo r e , dise n g a g e t h e
clutch before depressing the
brake pedal to stop the tractor.
(Manual Type)
•
•
•
CAUTION
pedal and front/rear driving pedals
depressed. (HST type)
(1) Range Gear Shift Lever (6 Speeds)
(C) Creep Speed (L) Low Speed
(N) Neutral (M1) Middle Speed 1
(M2) Middle Speed 2 (H) High Speed
(D) Drive
To Next Page
Loading...
Need help?
General
