The e ngine o i l is v e r y hot
while the engine is running
or right after the engine is
stopped. Be careful not to be
burnt.
Avoid oil contact while chang-
ing or adding engine oil and
wear eye protection to prevent
eye contact.
Prolonged and repeated con-
tact with the engine oil may
cau s e s kin d i s orde r s a nd
skin cancer. If skin contact is
made, wash thoroughly with
soap or hand cleaner as soon
as possible.
Keep the used oil out of reach
of children.
WARNING
To avoid personal injury:
Be sure to stop the engine
before changing the oil or re-
placing the lter.
Check the en gi ne oil l ev el
before every operation of the
tractor. If the engine oil is
insufficient, the engine can
be damaged, and this is not
covered by warranty. Be sure
to add the engine oil when its
level is below the lower limit
of the oil dipstick.
Do not dispose of used oil
and oil lter into drainage and
other places not designated
by regulations. Observe appli-
cable reg-ulations when dis-
posing used oil and lters.
•
•
•
CAUTION
Model
Oil capacity
(with lter)
ALL-US 1.4 U.S.gal. (5.3 L)
NX4510-EU/AU 2.1 U.S.gal. (8.0 L)
NX5010-EU/AU 2.0 U.S.gal. (7.7 L)
NX5510-EU/AU 1.4 U.S.gal. (5.3 L)
NX6010-EU/AU 1.4 U.S.gal. (5.3 L)
7. Run the start motor for approx. 10
seconds to deliver oil to each part.
8. Run the engine for approx. 5 min
-
utes and check if the oil warning
lamp comes on. If it does not come
on, stop the engine. (It is normal
for the oil warning lamp to be off
while the engine is running.
9. Check the engine oil level again
with the oil dipstick. If the level is
low, add more oil.
The engine oil filter should be
replaced when changing the en-
gine oil.
•
NOTE
To Next Page
Loading...
Need help?
General
