13
This is a proprietary document of Kirloskar Brothers Limited, Kirloskarvadi-416308, Dist-Sangli (India)
ISSUE DATE: 17.09.2010 LAST REV. DATE:
5.4 CORRECTIVE MAINTENANCE
PUMP TROUBLE
When investigating trouble with Kirloskar pumps, always remember that pumps have been
tested at the factory and are mechanically correct when sent out. Discounting the possibility
of damage during transit, most of the trouble in the field is due to faulty installation.
Investigation shows that the majority of troubles with centrifugal pumps result from faulty
conditions on the suction side.
BREAK DOWN-CAUSE-CHECK POINTS
In case of breakdown we recommend the location of the fault by referring the table for ‘Break
Down Check Points’ given at the end of this manual.
6.0 TECHNICAL DATA:
6.1 Models
‘DB’ type of pumps are available in models as referred to in1.1.Only three shaft units
(driving units) are used for complete range of ‘DB’ pumps. The models covered under
individual shaft units are given in interchangeability chart (6.2).
DB pumps are suitable for clean liquids having temp – 10 to + 100 °C.
6.2 Interchangeability Chart
To Next Page
Loading...
Need help?
General
