7
• CHECK FOR DAMAGED PARTS. Before further use of the tool, a guard or other part that is
damaged should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment of moving parts, binding of moving parts, mounting, and
any other conditions that may affect its operation. A guard or other part that is damaged should be
properly repaired or replaced.
• USE RECOMMENDED ACCESSORIES. Consult the product manual for recommended accessories.
The use of improper accessories may increase the risk of personal injury.
SERVICE SAFETY
• If any part of this tile saw is missing or should break, bend, or fail in any way; or should any electrical
component fail to perform properly: ALWAYS shut off the power switch and remove the plug from
the power source, and have the missing, damaged, or failed part replaced BEFORE resuming
operation.
• When servicing a tool, ALWAYS use only identical replacement parts. Follow instructions in the
Maintenance Section of this manual. Use of unauthorized parts or failure to follow Maintenance
Instructions may create a risk of electric shock or injury.
SPECIFIC SAFETY RULES FOR TILE SAW
WARNING: Be sure to read and understand all instructions in this manual before using
this tile saw. Failure to follow all instructions may result in electric shock, re and/or serious
personal injury.
WARNING: To reduce the risk of mistakes that could cause serious, permanent injury, do not
plug the tile saw into an electrical receptacle until the following steps have been satisfactorily
completed.
• COMPLETELY ASSEMBLE THE SAW (See ASSEMBLY INSTRUCTIONS)
• LEARN THE USE AND FUNCTION of the ON-OFF switch, blade guard, laser-adjustment knob,
overload protector, spindle lock, depth-stop-adjustment knob, depth-adjustment knob, bevel-cut-
adjustment knob, universal guide, etc. (See “Assembly” and “Operation” sections)
• REVIEW AND UNDERSTAND ALL SAFETY INSTRUCTIONS AND OPERATING PROCEDURES
in this manual.
• REVIEW THE MAINTENANCE METHODS for this saw (See”Maintenance” section)
• NEVER put your ngers or hands in the path of the saw blade or other cutting tool.
• NEVER REACH BEHIND the cutting tool with either hand for any reason. Do not reach behind the
blade to hold down the workpiece, support the workpiece, remove scraps, or for any other reason.
• NEVER use a hand position where a sudden slip could cause the ngers or the hand to move into
a saw blade.
• FIND AND READ ALL THE WARNING LABELS found on the tool (shown below).
To Next Page
Loading...
Need help?
General