ASSEMBLY INSTRUCTIONS
9.
CONNECTING
THE
GARDEN HOSE
CAUTION:
Always
observe all local regulations when connecting hoses
to
the water main. Some areas have
restrictions against connecting directly
to
public drinking water supply to prevent the feedback
of
chemicals
into the drinking
water
supply. Direct connection through a
receiver
tank or backflow
preventer is usually permitted.
• Uncoil the garden hose.
NOTE: There must
be
a minimum
of
10
feet of unrestricted garden hose between the water intake
and the garden hose faucet
or
shut off valve (such as a "Y" shut off connector).
Run water through the hose for
30
seconds to clean any debris from the hose.
Inspect the screen
in
the water intake.
If the screen
is
damaged, do not
use
the
machine until the screen has been replaced.
If the screen
is
dirty, clean it before connecting the garden hose
to
the machine.
With the hose faucet turned completely off, attach the end of
the
garden hose to the water intake.
Tightened
by
hand only.
A
B
A-Garden
Hose
8-Water Inlet Connector
14
OPERATING INSTRUCTIONS
A wARNING
Do
not allow familiarity with the product to make
you
careless. Remember that a careless fraction of a
second is sufficient
to
inflict serious injury.
A wARNING
Always
wear
eye protection with side shields marked
to
comply with ANSI Z87.1. Failure to do
so
could result
in
objects being thrown into your eyes resulting in possible serious injury.
A wARNING
Do
not use
any
attachments or accessories not recommended by the manufacturer
of
this product.
The
use
of
attachments or accessories not recommended can result
in
serious personal injury.
A wARNING
Never direct a water stream toward people or pets, or any electrical device. Failure to heed this warn-
ing
could result
in
serious injury.
APPLICATIONS
You
may use this product for the purposes listed below:
Cleaning boats, cars, trucks, motorcycles, outdoor furniture, grills, house siding, driveways, patios
and decks.
10. DETERGENT ADDING AND USE
Use
only
detergents
designed
for
pressure
washers;
household
detergents,
acids,
alkalines,
bleaches, solvents, flammable material,
or
industrial grade solution
can
damage the pump. Many
detergents
may
require mixing prior to use. Prepare cleaning solution
as
instructed on the solution
bottle.
SOAP APPLICATION
Soap is applied under low pressure high volume for optimum performance.
Soap can not be applied under high pressure with this machine.
Soap/detergent can only
be
applied with this machine when the black (75 degree) soap tip is installed.
15
To Next Page
Need help?
General
