13
kobalttools.com
ASSEMBLY INSTRUCTIONS
1. Unfolding and adjusting handle assembly
a. To raise handle assembly:
aligned with the slot between the cam locks (M) and
the mower housing.
Note:
lower cam locks (M) counterclockwise to free the
handle.
lower handle locks (M).
Note: If the lower handle is loose or does not seat
completely in the slot, turn the lower cam locks (M)
clockwise to secure the handle.
operating position. Make sure that the lower handle
is seated in the grooves at the bottom of the upper
handle.
upper cam locks (H).
Note: If the upper handle is loose or separated from
the lower handle, tighten the knobs on the upper
handle locks by turning them clockwise.
1a
F
H
M
WARNING
If any parts are damaged or missing do not operate this product until the parts are replaced. Using a
product with damaged or missing parts could result in serious personal injury.
Do not attempt to modify this product or create accessories not recommended for use with this
leading to possible serious personal injury.
Do not insert battery until assembly is complete and you are ready to mow. Failure to comply could
result in accidental starting and possible serious personal injury.
To prevent accidental starting that could cause serious personal injury, always remove the battery
from the product when assembling parts.
Never operate the mower without the proper safety devices in place and working. Never operate the
mower with damaged safety devices. Operation of this product with damaged or missing parts could
result in serious personal injury.
To Next Page
Loading...
Need help?
General
