Kobalt KOC 4124A-03 User Manual

16
CARE AND MAINTENANCE
All maintenance should only be carried out by a qualied service technician.
Before cleaning or performing any maintenance, remove battery from the tool. For safe and
proper operation, always keep the tool and its ventilation slots clean.
Cleaning
Always use only a soft, dry cloth to clean your string trimmer; never use detergent or alcohol.
Clear any grass that may have wrapped itself around the motor shaft or trimmer head. Keep
the air vents free of obstructions.
Storage
Clean the tool thoroughly before storing it.
Store the unit in a dry, well-ventilated area, locked-up or up high, out of the reach of children.
Keep away from corrosive agents, such as garden chemicals and de-icing salts.
TROUBLESHOOTING
WARNING:
• Turn the switch to the “OFF” position and remove battery from the tool before performing
troubleshooting procedures.
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Tool does not work. Low battery capacity. Charge the battery pack.
String trimmer stops
while cutting.
1. The motor shaft or
trimmer head is bound
with grass.
1. Stop the trimmer, remove the
battery, and remove the grass from
the motor shaft and trimmer head.
2. The motor is overloaded. 2. Move the trimmer head to cut the
grass no more than 8 in. of length
in a single cut. Remove the trimmer
head from the grass and restart
the tool.
3. The battery pack or
string trimmer is too hot.
3. Release the trigger switch, wait
for the tool to cool down, and then
start the tool again.
Trimmer head will not
advance line.
1. The motor shaft or
trimmer head is bound
with grass.
1. Stop the trimmer, remove the
battery, and clean the motor shaft
and trimmer head.
2. There is not enough line
on the spool.
2. Remove the battery and replace
the cutting line; follow the section
“Line Replacement” in this manual.

Kobalt KOC 4124A-03 Specifications

General

Brand	Kobalt
Model	KOC 4124A-03
Category	Trimmer
Language	English