22
Printed in China
TROUBLESHOOTING
WARNING
• Place the trigger switch (M) in the OFF position and remove the battery before performing
troubleshooting procedures.
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Tool does not work.
1. Low battery pack
capacity.
1. Charge the battery pack.
2. Battery pack is too hot. 2. Wait for it to cool down, at which
point it can be started again
Motor runs, but
chain does not
rotate.
1. Chain does not engage
drive sprocket.
1. Reinstall the chain, making sure that
the drive links on the chain are fully
seated on the drive sprocket.
2. Chain tension is too
tight.
2. Re-tension the chain. Refer to the
section “Adjusting the Chain
Tension” in this manual.
Motor runs, the
chain rotates but
does not cut.
1. Dull chain. 1. Replace or sharpen the chain.
2. Chain is installed
backwards.
2. Reinstall the chain to reverse the
direction of the chain.
WARRANTY
For 5 years from the date of purchase, the power tool is warranted for the original purchaser
to be free from defects in material and workmanship. This guarantee does not cover damage
due to abuse, normal wear, improper maintenance, neglect, unauthorized repair/alteration, or
expendable parts and accessories expected to become unusable after a reasonable period of
use.
If you think your product meets the above guarantee criteria, please return it to the place of
purchase with valid proof of purchase and the defective product will be repaired or replaced at
no charge. This guarantee gives you specic legal rights, and you may also have other rights
that vary from state to state.
L G SOURCING, INC. MOORESVILLE, NC 28117
To Next Page
Loading...
Need help?
General
