EasyManuals Logo
Home>Kobalt>Battery Charger>KRC 30-06

Kobalt KRC 30-06 User Manual

Kobalt KRC 30-06
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
kobalttools.com
4
2. Checking the charge
If the battery pack does not charge properly:
Check the current at the power outlet with another tool. Make sure that the outlet is not turned off.
Check that the charger contacts have not been shorted by debris or foreign material.
If the air temperature is above 100ºF or below 45ºF, move the charger and battery pack to a
room temperature location.
3. Charger mounting
This charger can be installed hanging on a wall
using #8 screws (not included).
Locate the placement for the charger to be wall
mounted.
If fastening to wood studs, use 2 wood screws (not
included).
Drill two holes on center 4.5 in. apart ensuring that
they are vertically aligned.
If fastening to drywall, use wall anchors (not
included) and screws to secure the charger to
the wall.
3
OPERATING INSTRUCTIONS
CARE AND MAINTENANCE
Note: If the battery and the charger won’t be used for a
long time, remove the battery from the charger and pull
out the AC power plug.
Keep the charger clean and clear of debris. Do not allow foreign material to get into the recessed
cavity or onto the contacts. Wipe the charger clean with a dry cloth. Do not use solvents or water,
and do not place the charger in wet conditions.
Unplug the charger when there is no battery pack in it.
The battery pack may be stored in the charger; however, it is recommended to disconnect the
charger from the power source.
Check that the charger contacts have not been shorted by debris or foreign material.
Store the charger at normal room temperature. Do not store it in excessive heat. Do not use the
charger in direct sunlight. Recharge at room temperature between 45˚F and 104˚F. If the battery
pack is hot, allow it to cool inside the charger.
If the battery is inserted into the charger when warm or hot, the charging LED indicator light on the
charger may switch on and illuminate RED. If this occurs, allow the battery to cool inside of the
charger. The battery will begin charging once it has returned to charging temperature.
WARNING

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kobalt KRC 30-06 and is the answer not in the manual?

Kobalt KRC 30-06 Specifications

General IconGeneral
BrandKobalt
ModelKRC 30-06
CategoryBattery Charger
LanguageEnglish

Related product manuals